Enable or Disable Existing Hooks Using the Auth0 Command-Line Interface BETA

Profile Name

All of the examples on this page use auth0-profile as the name of the profile. This is the same profile name used when installing wt-cli and can be obtained from Step 2 of the instructions set located on Auth0 Management Dashboard's Webtask page.

For each extensibility point, you may have either no associated Hooks enabled or one associated Hook enabled.

By default, the Auth0 CLI creates new Hooks in a disabled state.

Enable Your Hook

The following command enables your Hook:

auth0 enable my-extension-1 -p auth0-default

By enabling a given Hook, the Auth0 CLI disables all other Hooks associated with the same extensibility point.

Disable Your Hook

The following command disables your Hook:

auth0 disable my-extension-1 -p auth0-default